Speeduino 202402 STM PRO firmware release is available through the Firmware loader App.
https://github.com/noisymime/speeduino/releases/tag/202402 to see the changes.
Join the Conversation
Leave a comment
Speeduino 202402 STM PRO firmware release is available through the Firmware loader App.
https://github.com/noisymime/speeduino/releases/tag/202402 to see the changes.
hi i was wondering if you have a drive by wire add on available for the stm pro ecu? for a ford 8cyl with coil on plug and a lexus beams 4cyl
Hi, Yes I can do a DBW for the Pro ECU’s. They are not directly available from the website, You will have to notify me before ordering and i can arrange payment for the modules.
Hi,
I am looking to build a 8 channel DBW intake using 8 Bosch DBW throttle boddies (52mm used in Ford Ecobust 1.6 engines).
It is Ford V8 application using standalone ECU Fast XFI2.0 that does not support DBW, so would like to get this to be a standalone solution; ideally, if possible, to take in Idle valve signal from ECU to directly control Idle and obviously to send out TPS signal to ECU.
Is that something you would be able to help with and do you think that current requirement of 8 DBW throttle bodies might be too high/chalenging on the electrical system?
Thanks, Robert
I don’t think I would like to tackle that, to many failure points. Yes I have now some external DBW controllers completed and they do have input for the PWM idle control, you would need 1 controller per throttle. Something custom could be made using multiple driver chips on one board.
Hi, we are wanting to replace a cable driven accelerator on a classic car that has no ECU.
We and to use a Bosch pedal and an actuator and have seen your setup to do this. Can we buy 2 of them?
Hi, I have a standalone controller, But in your setup you won’t have any idle control as it needs a PWM signal from a ECU to control the idle.
We are running the Holley sniper EFI TBI so we have built in IAC to control the idle.